On a phone, pinch to zoom or turn the phone sideways.

Loads and efficiency

Loads, efficiency, self-locking – TS 031 444 worm gearboxes

Permissible overhung loads on the output shafttypes S and E
a FN< 10n2 [min⁻¹]10 – 25n2 [min⁻¹]25 – 50n2 [min⁻¹]50 – 75n2 [min⁻¹]75 – 100n2 [min⁻¹]100 – 170n2 [min⁻¹]> 170n2 [min⁻¹]
50Fr3 0002 2001 7001 3001 1001 000900
Fa1 8001 3001 000700500300250
63Fr3 9003 2002 5001 9001 6001 5001 300
Fa2 2001 8501 5001 1001 000800700
80Fr4 1004 1003 7003 0002 5002 1002 000
Fa2 4002 4002 1001 8001 5001 0001 000

Radial load Fr acts at the middle of the output shaft end, axial load Fa along the axis; both may act at the same time. Values are guide values for mounting 1. Please consult us on other loads on the output shaft.

Efficiency
η = M2 · n2 / (9550 · P1)

For a run-in gear set under near-rated load, efficiency is calculated from the values in the rating tables.

Starting efficiency
u1016202531.540506380
ηR0.680.580.550.50.420.40.360.310.26

When starting under full load, efficiency depends on the lead angle of the worm and on static friction – higher input power is required.

Self-locking

If the lead angle of the worm is smaller than the friction angle, the gear set cannot be turned from the output – it is self-locking. This mostly applies to ratios above 40, where efficiency is about 0.5.

A self-locking gear set is no substitute for a brake – under vibration and shocks self-locking is unreliable. Please consult us on drives with high rotational energy and a ratio close to self-locking.

Weight
sizetype Skgtype Ekg
TS 509.7S + motor
TS 6314.0S + motor
TS 8020.7S + motor

Weight without foot. With foot it is approx. 15 % higher; for type E add the weight of the motor.

Send an enquiry for this item

Tell us the size, ratio, type, mounting, mounting position and quantity – we will prepare a quotation or help you choose.

Send an enquiry