On a phone, pinch to zoom or turn the phone sideways.
Operation
Installation, lubrication and maintenance – TMP worm gear screw jacks
Mounting the unit
The mounting face and the guide must be perpendicular to each other in all directions, the nut mounting faces perpendicular to the screw axis.
The housing can be mounted on either face perpendicular to the screw axis – use the one that takes the largest axial forces; keep the hole in the mounting face as small as possible.
Linked units must have parallel spindles and mounting faces perpendicular to the guides, otherwise they may jam.
The reaction torque on the screw (types N, VS) or on the nut (type RS) must be taken up by the driven mechanism.
Direction of rotation
Standard lead screws have a right-hand thread, the worm gear a right-hand lead. Left-hand screws on request.
ηS – connecting shafts 0.75 – 0.95 (depending on length and bearings), ηK – bevel gearboxes approx. 0.9. Keep the same direction of rotation, place the motor next to the most heavily loaded unit and check Mk max at the input of units in series.
Lubrication and maintenance
The gearboxes are supplied filled with grease: types N and VS with Shell Alvania R2, type RS and TMP 80 with MOL Alukomplex 00.
Every 50 operating hours check the screw lubrication, clean and relubricate as needed; on types N and VS also top up grease through the lubrication plug.
TMP 80 is sealed – only the lead screw is relubricated. On types N and VS replace the whole fill after 700 hours.
In dusty environments protect the screw with MA bellows or clean it more often.
Safety
After a short running-in period retighten all fixing screws.
After about 200 hours (sooner in harsh conditions) check nut wear by the axial play; if it exceeds ¼ of the pitch, replace the nut (wheel).
Dismantling types N and VS
Loosen the locking screw of the bearing cap, unscrew the lead screw and remove the cap with a spanner. On assembly tighten the cap to 10 times the torque Mm, loosen and retighten lightly to torque Mm.
TMP 25
TMP 32
TMP 45
TMP 63
TMP 71
TMP 80
Mm [Nm]
2
9
13
40
60
70
Tn [kg]
0.08
0.14
0.24
0.8
1.07
1.6
Mm – tightening torque of the bearing cap, Tn – grease fill.
Send an enquiry for this item
Tell us the size, type, stroke and quantity – we will prepare a quotation or help you choose.